SPOON SPORTS AERO BUMPER, FRONT
Overview
- Available Quantity: 10
- Condition: New
- Listed From: 2022-01-25 14:37:27
- Product ID: 3579
SPOON SPORTS AERO BUMPER, FRONT
Product No : 71101-AP1-001
Applicable model: S2000
Adaptive model: AP1-100, AP1-110, AP1-120, AP1-130, AP1-135, AP1-200, AP2-100, AP2-110
Sales unit : pcs
CODE: CODE: S
Packing size: 71x182x54cm
Engine type: F20C, F22C
Spoon has been developing S2000 aero parts since 2007 and has demonstrated excellent performance in super endurance races, etc., but in pursuit of further aerodynamics, we released a new front / rear bumper for S2000.
Introduced in the actual battle from last year, it has a simple design but performance that surpasses the old model, and at the same time it suppresses air resistance, and at the same time, it is possible to obtain downforce by controlling the air flowing on the bottom of the car body.
With this aero, you can maximize the power of the engine, and you can withstand the lateral G without reducing the speed as much as possible even in the corners, which is also effective for fuel efficiency.
The development uses the latest CFD analysis, reviews the way the air flows from the front end of the bumper to the engine hood,
and reduces the air resistance by smoothing the shape.
In addition, both ends of the bumper are inflated more than the genuine one, and by scooping out the lower part, the
same effect as attaching the canard is obtained and downforce is generated.
In addition, the effect of sucking out the air inside the wheel arch is generated by utilizing the air flow.
The above effects could be confirmed by performing fluid analysis.
Remarks & special notes
Material: FRP white gel coat finish
(Caution) Wax is used in the product manufacturing process, so be sure to degreas it before painting.
After that, roughen the surface with # 800 water resistant paper.
In addition, there may be small pinholes, scratches, cracks, etc. on the surface, but if you can base it with a polyester putty / surfacer, it will be finished beautifully.
・ Be sure to temporarily align the product before painting.
-The product will be deformed in an environment such as a painting booth / heater, so please allow it to dry naturally without applying heat.
・ When the temperature is low, such as in winter, or when the humidity is high, dry the product at 40 ° C or less.
・ Do not partially heat. It may cause distortion.
Please feel free to contact us upon order.